Critical things missing – copied from earlier post
- Cam followers (1SZ-FE solids. Need to measure old ones when I get the head back)
- Intake + throttle body (intake is being made, prototype seen again!)
- Injectors + connectors (Bosch EV14 1000cc with ethanol compability)
- Wiring loom (nope, nothing done yet)
- Intercooler (stock one wont do. Must order that A2W (AVT Chargecoolers?))
- Exhaust (Is being made)
- PISTONS! (maybe something else than wiseco?)
- Head gasket (HKS?)
Non-critical things missing
- CAN Bus wires for the ecu (found something interesting for this)
- New plugs (maybe, I got iridiums both on my current and spare engine)
- Clutch plate (maybe, no idea about the current condition)
- 2-component silver paint for the epoxy painted parts
- Ethanol compatible fuel pump
- Fuel system (hoses, etc.) ethanol compatible
- Fuel pressure regulator (I had one but it is at Beldins’)
- Crank wheel/harmonic balancer (the original will do until I can buy one (BHJ?))
- Cam gears (maybe later and maybe toda. HKS Camshafts work with stock ones)
- Gear shifter bearings
- Gear shifter that small bearing that is at the side of the shifter
- Rear motor mount + damping?
- Shift base bushings
- Shift lever bushing?
- Titanium axle bolts 🙂
- Silicone coolant hose kit
- Engine bay coolant bleeder screw
Done list
- Cam covers (Done! Powdercoated)
- Crank bearings (Done! Friction reducing coating)
- Conrod bearings (Done! Friction reducing coating)
Uncertain
- Idle air valve (uncertain)
- Turbo hardware kit (uncertain)
- Aluminium radiator
Leave a Reply