Front caliper and rotor

Posted on20th October 201626th March 2017AuthorsearockLeave a comment

Finally got all the front end bits together. Not much to see here, because SW20 parts will fit into SW20 parts without any problems 😀

Leave a Reply

Subscribe

searock on Differential and the bearingsHi, the wide race one has been discontinued
searock on A 240km/h speedo for the AW11Its just normal euro version gauge.
Trinidrifter on Differential and the bearingsAnyone has the Toyota part number or any other number for those bearings? Especially the one with th…
Kenneth on A 240km/h speedo for the AW11hi mate，where do you get the MR2 AW11 240km/h Face Gauge Cluster？I am searching for it.
Rebirth_mr2 on Converting from 4×100 to 5×114.3Thanks for the reply on the injectors! Was able to find the tophats to make them fit. New question n…
searock on New injectors and fuel pumpI got mine as a complete, 61mm tall package. The adapters included were generic to convert the top e…
Rebirth_mr2 on New injectors and fuel pumpWhat adapters did you buy for them to be a similar size to the 4agze? Just ordered the same injector…

Dyno pull for legal reasons
9th November 2019
No Comments
After first tuning session
6th November 2019
No Comments
Dyno days part one
27th October 2019
No Comments
Grounding and reverse light wiring
27th October 2019
No Comments
Extending the stock throttle cable
27th October 2019
No Comments
Replacement for the broken boost pressure recirculation valve
27th October 2019
No Comments
Stock tacho with aftermarket ECU
27th October 2019
No Comments
Building a coil pack support with some lipstick for pigs
27th October 2019
No Comments
Learning to weld
27th October 2019
No Comments
Installing turbo hoses
27th October 2019
No Comments
Nice sound
2nd September 2019
No Comments
Odd jobs
2nd September 2019
No Comments
Cam angle sensor and water pump problems
2nd September 2019
No Comments
Lots of photos
2nd September 2019
No Comments
Coilpacks and alternator wiring
2nd September 2019
No Comments
Ice cream
2nd September 2019
No Comments
Fuel tank
2nd September 2019
4 Comments
Wiring continues – some wins
2nd September 2019
4 Comments
Let the wiring begin
2nd September 2019
No Comments
New engine!
2nd September 2019
No Comments
Swapping gearbox and clutch from old engine to new
2nd September 2019
No Comments
Engine removal
2nd September 2019
No Comments
The very last start of the engine
23rd May 2019
No Comments
Quick dash to this day
23rd May 2019
No Comments
Wrapping the exhaust manifold and downpipe
23rd May 2019
No Comments